Creation of Multiple viewports, Scaling the drawing and setting in Template in AutoCad

AIM : To create of Multiple viewports, Scaling the drawing and setting in Template in AutoCad.

1. Create a layout of the Plan and Section A of the project in Challenges 7, using the template Tutorial-mArch.dwt in a scale as given in the Figure. Use the MV command to create the viewport of the size as shown in Figure. Also, use ATTEDIT command to edit the information in the title block. Use A1 size for the layout. Take a plot.

PROCEDURE : BY USING EXISTING TEMPLATES AND MV COMMAND IN 2 VIEWPORTS THE FOLLOWING VIEW IS OBTAINED.

AIM: Create a layout of the Kitchen drawn in Challenge 9 as shown in Figure. Use the scale as shown in the Figure. Use A4 Size page for the layout. Take a plot.

PROCEDURE : BY USING EXISTING FLOOR PLANS AND MV COMMAND IN 4VIEWPORTS THE FOLLOWING VIEW IS OBTAINED.

AIM :Create a layout of the section created in Challenges 9.

Use scale as mentioned in the Figure. Use MV command create multiple viewports. Take a plot.

PROCEDURE : BY USING EXISTING FLOOR PLANS AND MV COMMAND IN 3 VIEWPORTS THE FOLLOWING VIEW IS OBTAINED.

THE ABOVE RESUKTS ARE OBTAINED.