Creation of Multiple viewports, Scaling the drawing and setting in Template in AutoCad

1). Aim-

To plot the plan and section of a residential drawing into a A1 sheet paper.

Procedure-

• Create layout for plan and section and name it accordingly.
• Setup the page of the layout as per requirements.
• Use M.V commands to create the view port on layout.
• Use view command to set the corresponding view for both view.
• Plot the layout into pdf by using the command cntrl + p and then setup the requirements of the page.

2). Aim-

To create layout and plot of kitchen raft.

Procedure-

• Create layout for Kitchen raft and name it accordingly.
• Setup the page of the layout as per requirements.
• Use M.V commands to create the view port on layout.
• Use view command to set the corresponding view for both view.
• Plot the layout into pdf by using the command cntrl+p and then setup the requirements of the page.

3). Aim-

To plot the plan and section of a residential drawing into a A1 sheet paper.

Procedure-

• Create layout for and name it accordingly.
• Setup the page of the layout as per requirements.
• Use M.V commands to create the view port on layout.
• Use view command to set the corresponding view for both view.
• Plot the layout into pdf by using the command cntrl+p and then setup the requirements of the page.