Creation of Multiple viewports, Scaling the drawing and setting in Template in AutoCad
Aim: Creation of Multiple viewports, Scaling the drawing and setting in Template in AutoCad
Procedure:
1. Create a layout of the Plan and Section A of the project in Challenges 7, using the template Tutorial-mArch.dwt in a scale as given in the Figure. Use the MV command to create the viewport of the size as shown in Figure. Also, use the ATTEDIT command to edit the information in the title block. Use A1 size for the layout. Take a plot
1. Click on layout.
2. Right-click on the layout
3. Go to page setup manager
4. Modify the page setup manager
5. Select the paper size to A4
6. Select the scale size to 1:50
7. Select the color pattern
8. select command MVIEW
9. Drag the drawing in the layout page
10. Use zoom command and select 'object'
11. Select the view which is needed in the layout from the drawing.
2. Create a layout of the Kitchen drawn in Challenge 9 as shown in Figure. Use the scale as shown in the Figure. Use A4 Size page for the layout. Take a plot
1. Click on layout.
2. Right-click on the layout
3. Go to page setup manager
4. Modify the page setup manager
5. Select the paper size to A4
6. Select the scale size to 1:2
7. Select the color pattern
8. select command MVIEW
9. Drag the drawing in the layout page
10. Use zoom command and select 'object'
11. Select the view which is needed in the layout from the drawing.
3. Create a layout of the section created in Challenges 9.
Use scale as mentioned in the Figure. Use MV command create multiple viewports. Take a plot.
1. Click on layout.
2. Right-click on the layout
3. Go to page setup manager
4. Modify the page setup manager
5. Select the paper size to A4
6. Select the scale size to 1:2
7. Select the color pattern
8. select command MVIEW
9. Drag the drawing in the layout page
10. Use zoom command and select 'object'
11. Select the view which is needed in the layout from the drawing.
Conclusion : In this way the multiport is created.