Creation of Column Schedule and Drawing Template using AutoCad

Aim: To draw given drawing using Autocad Software.

Procedure for Drawing 1:

• In command prompt type Units and change the units to Engineering selecting suitable precision.
• In command prompt Type Line and draw the outline of the table.
• In command prompt type OFFSET and take the offset of the lines of suitable distance to show rows.
• In command prompt type Dtext and type the text as given of height 8".
• For "Terrace to Mumty" Text take the angle of text 90deg.
• For Diameter symbol type %%C in text box.
• In command prompt type RECT for drawing rectangle to show column.
• Take the OFFSET of the rectangle of suitaible distance.
• For reinforcement of main steel use CIRCLE command.
• Place the Circle at suitable distances and draw the tangential lines to show the stirrups using LINE command in command prompt.
• For Binding part use line command.
• In commmand prompt type TRIM and erase the extra part of the column and the table.
• Align the text and close the table.

Procedure for Drawing 2:

• In command prompt type UNITS and change the units to Engineering with suitable precision.
• In command prompt type LINE and draw one vertical and horizontal line.
• In command propmt type OFFSET and take offset of both vertical and horizontal line of suitable distance showing rows and the column of the table.
• In command pompt type DTEXT and type the text at respective places.
• Align the text and trim out the extra part of the table using TRIM command and close the table.

Procedure for Drawing 3:

• In command prompt type UNITS and change it to Engineering with suitable precision.
• In command prompt type DTEXT and type the text.
• In command prompt type LINE and draw the box covering entire text using line command.
• In command prompt type LINE and draw the table.
• In command propmt type Dtext and type text at respective places in the table.
• In command prompt type TRIM and trim out the extra part of the table.
• Align the text and close the table

Procedure for Drawing 4:

• In command prompt type UNITS and change it to Engineering with suitable precision.
• In command prompt type Xline and draw one vertical and one Horizontal line having one intersection point,.
• In command prompt type TRIM and trim out the Half part such that it will be left with the corner.
• In command prompt type OFFSET and take the offset of both horizontal and vertical line for rowas and the column of the table of suitable length.
• In command pompt type DTEXT and type the text in respecive places of the table.
• Align the text and close the table.
• In command prompt Type TRIM and trim out the extra part of the table.

Procedure for Drawing 5:

• In command prompt type UNITS and change it to Engineering.
• In command prompt type LINE and draw the vertical line of suitable height and take the offset of it using OFFSET command.
• In command prompt type LINE and draw the section line of suitable measurement and also divide the column in three parts.
• In command prompt HATCH and select the AR-CONC to show the concrete part of the block and ANSI32 to show the brickwork of the block.
• In tool bar go to Annotate and select multi leader to show the TOP level and ground level dimension.
• In command prompt type LINE and draw the arrow to show Brickwork labelling.
• In command prompt type DIMLIN to show the linear dimension.
• In command prompt type DIMSTYLE and modify the elements of the dimension.
• In command prompt type DTEXT and type the text shown in the given figure.