Creation of Column Schedule and Drawing Template using AutoCad

Aim - Creation of Column Schedule and Drawing Template using AutoCad.

Procedure -

1. Create a column schedule as shown in the figure.

Note: Create a column schedule with the help of lines. Also, insert text with the help of Dtext command or Single Line text.

Hint: Use font name: romans.shx; Height: 8”, Justify: Left

a.) The above sketch was drafted using the 'unit' command

b.) The MTEXT command was used for setting the text.

c.) Virtical text was set by using the Command MTEXT and then angle of 90 degree was been set.

d.) The column schedule was set by using the Line command and offset Command.

2. Create a window schedule as shown in the figures:

Window Schedule

a.) The above sketch was drafted using the 'unit' command

b.) The MTEXT command was used for setting the text.

c.) Horizontal text was set by using the Command MTEXT and then angle of 0 degree was been set.

3. Create the drawing template as shown in the figure:< Use the Notes as in the figure>

a.) The above sketch was drafted using the 'unit' command.

b.) The font size was set to 2 unit and 5 unit for tha larger size

c.) The MTEXT command was used for setting the text.

d.) Horizontal text was set by using the Command MTEXT and then angle of 0 degree was been set.

e.) The column schedule was set by using the Line command and offset Command.

4. Create the list of drawing schedule as shown in the figure:

a.) The above sketch was drafted using the 'unit' command.

b.) The font size was set to 3 unit and 5 unit for tha larger size

c.) The MTEXT command was used for setting the text.

d.) The column schedule was set by using the Line command and offset Command.

5. Create the Beam detail as shown in the figure and provide text wherever given.

a.) The above sketch was drafted using the 'unit' command

b.) The MTEXT command was used for setting the text.

c.) Virtical text was set by using the Command MTEXT and then angle of 90 degree was been set.

d.) The column was set by using the Line command and offset Command.