Creating various 3D Models like Furniture, Footing, Girder, Column drop with panel and Gable Wall in AutoCad

Aim: Creating various 3D Models like Furniture, Footing, Girder, Column drop with panel, and Gable Wall in AutoCad

Procedure :

Drawing 1

1. Mode is set to 3d Modelling.

1. Unit is set to 'Decimal' and 'Feet'

2. Using the Line Command the height of the Table is set to 2'6" in Zaxis

3. Using the Line Command the Length of the Table is set to 3' in Yaxis

4. Using the Line Command the Length of the Table is set to 2' in Xaxis

5. The offset is set to 2"

Drawing 2

2. Create the 3d Model of an Isolated footing as shown in Figure.

1. Unit is set to 'Decimal' and 'Feet'

2. The square is set to area 4' x 4'

3. The square is extruded to 6"

4. The other square of 1' x 1' is set at a height of 2'

5. Then the upper and lower square corners are been joined.

Drawing 3

3. Create the 3D view of the AASTHO Type Girder.

1. Unit is set to 'Decimal' and 'Feet'

2. The view is set to top view

3. Using the Line command the Structure is drafted using the given dimension.

4. Then the structure is extruded to 10'

5. Using the 3drotate the Structure is set to particular view given above

Drawing 4

4. Create a 3d Model of a drop column with panel as shown in section and isometric view

1. Unit is set to 'Decimal' and 'Feet'

2. The view is set to Top view

3. Using the dimensions given above the Structure is drafted.

4. Circle is drawn of diameter 3' and a square is set to dimension 8' x 8'

5. The circle is extruded to 10'

6 And the square is extruded to 2"

7. And the structure is set to particular view.

Drawing 5

5. Create the 3d model of a wall as shown in Figure. Consider wall thickness as 9”

1. Unit is set to 'Decimal' and 'feet'

2. The total height is set to 12'6"

3. The offset is set to 2"

4. And the struture is been drafted.

Conclusion. Using the 3d modelling mode the above given structure is drafted