Creating Kitchen layout, Hatching of Architectural elements and sectional view of an Industrial Building in AutoCad

I'm: Creating a Kitchen layout, Hatching Architectural elements, and sectional view of an Industrial Building in AutoCad

Procedure :

A. Create the layouts of the Kitchen and provide a hatches pattern as shown. Also, use blocks wherever required. Provide appropriate dimensions in the plan. Assume the size of doors, appliances, and others as per the standards.

1. The unit is set to 'Decimal' and 'Meter'

2. The limit is Set to 'Left Corner' - 0,0 'Right Corner' - 10,10

3. Using the 'Xline' Command the vertical and horizontal line is set.

4. Using the 'offset' Command the external wall width is set to 0.250 m.

5. The Horizontal and Vertical Distance of the Kitchen is taken 4300 x 3200

6. The other drafting in the kitchen oven, Sunk, etc is drafted Using the command 'Trim', 'Line', Offset. etc.

7. The 'Hatch' Command is used to hatch the external walls wherever necessary.

B. Create the elevation of the plan created in Challenges 7 and apply proper hatch in the walls, doors, windows, and other architectural elements. Refer to the dimensions in the Plans and sections in Challenges 7.

1. The unit is set to 'Decimal' and 'Millimeter'

2. The limit is Set to 'Left Corner' - 0,0 , 'Right Corner' - 8000, 8000

3. Using the 'Xline' Command the vertical and horizontal line is set.

4. Using the 'Line' Command The height of the building was set to 6000 mm

5. Width of the Building is 5000 mm

6. The window size is drafted or 600 x 500 mm using the 'Line' Command, and 'Offset' Command.

7. And the total Elevation Plan is Completed.

C. Create the section view of an industrial building as shown in Figure. Provide appropriate hatches and dimensions wherever required. Also, provide annotations to the drawing

1. The unit is set to 'Decimal' and 'Millimeter'

2. The limit is Set to 'Left Corner' - 0,0 , 'Right Corner' - 8000, 8000

3. Using the 'Line' Command The Section Plan is Drafted.

4. The wall width is taken 200 mm

5. Using the 'Hatch' Command The Section Wall is Htached with a pattern given in the drawing

6. Using the 'Text' Command the Text is used wherever necessary for the Indication of various parts is the drawing accordingly.

7. And the total section is completed.

Conclusion: The Given Elevation, Section, and Layout Plan is Drafted as given above.