Creating Architectural and Structural model with 3D rendering using REVIT

Find the attachment 

Q1.State the primary load cases to be considered for design.The primary load cases that are to be considered for design are listed below:Dead Load (IS 875: Part I).Live Load (IS 875: Part II).Wind Load (IS 875: Part III).Snow Load (IS 875: Part IV).Seismic Load (IS 1893: 2016).……………………………………………………………………………………………………………………………………………….2.…

1.1 How will you assign Circular section to column? The detailed procedure of assigning the circular section to column is discussed below: So in order to assign the circular section to the column first we need to go to the properties panel. Then click on the option Define. Then there will be another dialogue box called…

1. a) AIM : Write the steps involved to upload a .std file through web mail? Introduction :  STAAD pro ( Structural Analysis and Deign program is the abbrivation for the STAAD it is the connected version new version used to analize the RCC structure and steel structure by using this software ) It Include the GUI Graphic…

 Use the Architecture/ Structure Project file developed by you in Week 6 to 8. Export the Revit architecture and structure model to Navisworks Cache file following the export settings discussed in class Aim: Export the Revit architecture and structure model to Navisworks Cache file following the export settings Tools:…

1)Select the type of structure you want to build from one of the three below        a. Multi Unit Residential Apartment        b. Office Buildings        c. School ANSWER:  My model represents a Multi Unit Residential Apartment .    2) Assume reasonable…

procedure: Open a new file  go to the manage tab and select Dynamo  open new file.search code block and select the code block Renamed it to Start, end, Step value search Range and connect the start to start end to end and step to step value search points by coordinate and connect the seq tox search the Formula…

                                    Objective of this challenge is to understand the concept of creating sheets view , create floors , create roofs and change the roof slope angles, create ceilings and editing , camera views , create…

1)     2)     3)     4)     5)     6)  

1)     2)         3)  

1) Kitchen Layout     2) Elevation      3) Section   

1)      2)     3)     4)     5)  

Important drawings for project    Centreline drawing  Footing and column layout with reinforcement details  Column Schedule with reinforcement etails  Plinth beam layout with reinforcement details  First floor beam layout with reinforcement details  firstfloor slab layout with reinforcement…

AIM: To Calculate the Concrete Mix Design for M35 grade concrete with fly ash & M50 grade concrete without Fly ash   INTRODUCTION: Concrete mix design is the method of finding the precise proportion of cement, sand and aggregates for concrete to achieve the target strength in structures, therefore concrete…