Creating a Wardrobe detailed drawing, Floor Plan, Kitchen Layout and Column Detail using AutoCad

AIM: Creating a Wardrobe detailed drawing, Floor Plan, Kitchen Layout, and Column Detail using AutoCad.

Procedure :

1. Draw the elevation and details of a wardrobe as shown in the Figure below. After sketching, you need to provide the dimensions and text with the use of layers. Use proper text styles and dimension methods to document it. Also, assume dimensions, wherever needed.

a. All the dimensions are in mm

b. By using the command 'unit' The dimensions were set to mm

c. The above sketch was drafted by using the command (Trim, Offset, Line command)

d. Text was added using the text command Mtext

2. Draw the floor plan as shown in the Figure. Use the proper drafting tools to sketch the plan. Do not hatch or draw the furniture. You need to draw the floor plan with the following:

Note: You can also import the Floor_Plan.pdf into your current drawing and start working on the project. You need to scale the imported pdf file using the reference option. All dimensions are in mm.

1. Walls (Exterior and Interior)

Wall Thickness: Exterior Wall- 230mm, Interior Wall: 150 mm (Wherever Required)

2. Doors and Windows: Assume the size of the doors and window.

2.1 Stairs: Tread-300mm, Riser-150mm

3. Insert Text wherever required
4. Insert the dimensions using the proper dimension technique

Answer: The limit of the area was set using the command 'LIMITS' 0,0 minimum.

b. External wall thickness was taken at 230mm

c. Internal wall thickness was taken at 150mm

d. The stairs Tread - 300m, Riser - 150mm

e. The unit was set to Architectural and mm

f. And the sketch was been drafted in this way

3. Create the Kitchen Layout as shown in the Figure below. Also, use proper dimension techniques to dimension the kitchen layout. Also, insert text wherever required. All dimensions are in mm.

a. The unit was set to mm

b. The external wall was set to 9"

c. Sketch was drafted using the command Line command, Trim Command, and Offset Command.

d. The text was added using the text command Mtext.

4. Sketch the column details as shown in Figure. Insert dimensions and text in the figure. Refer to the bar sizes from the schedule.

8mm ---- 0.31 Inches

25mm--- 1 inch

16mm—0.62 inches

Answer - The above sketch is about the column details.

b. The Dimension was set by using the unit command.

c. The dimensions were set as follows:

8mm ---- 0.31 Inches

25mm--- 1 inch

16mm—0.62 inches

d. The text was added using the text command Mtext.

5. Draw the Raft Layout as shown in the Figure. Assume the column size as per your knowledge. You can take the sizes as 24”x24”, 9” x 24”, 9” x 18”, and 9’ x 24”. You can import the raft_foundation.pdf to ensure the missing dimensions

a. The Dimension was set by using the unit command.

b. The Dimension was set to Engineering

c. The text was added using the text command Mtext.

d. The text was set to the angle of 90 degrees wherever necessary.

e. The external wall thickness is 9"

f. The internal wall thickness is 4"