Creating a Layout, Section and Elevation with dimensions using AutoCad

AIM: 1. Create the Plan and Sections as shown in the Figures. Use proper dimension techniques and dimension styles to document the project. Assume the sizes of the doors and windows as per construction standards. Refer to sections for stair details if required.

Procedure :

Drawing 1 :

1. The Limit was set first

2. Then the Unit is set to Decimal

3. The drawing is drafted by using the command Line, Offset, Trim, etc

4. With the help of this command the drawing (1st, 2nd, 3rd Floor Plan) is been drafted.

5. With the help of the text command the text is been used at the angle of 90 degrees wherever necessary.

Drawing 2 :

1. The Limit was set first

2. Then the Unit is set to Decimal

3. The drawing is drafted by using the command Line, Offset, Trim, etc

4. With the help of this command the drawing (Section A-A) is been drafted.

5. The Dimension of windows, Doors were Assumed.

6. With the help of the text command the text is been used at the angle of 90 degrees wherever necessary.

Drawing 3 :

1. The Limit was set first

2. Then the Unit is set to Decimal

3. The drawing is drafted by using the command Line, Offset, Trim, etc

4. With the help of this command the drawing (Section B-B) is been drafted.

5. The Dimension of windows, Doors were Assumed.

6. With the help of the text command the text is been used at the angle of 270 degrees wherever necessary.