Creating a Floor plan, Footing detail and Isometric view using AutoCad

Aim and Introduction of the project:-

Creating a Floor plan, Footing detail and Isometric view using AutoCad

Here we are using Auto CAD software to creat the geometries. Auto CAD is software which creat drawings with automation, collaboration, and machine-learning features. Architects, engineers, and construction professionals use AutoCAD to design and annotate 2D geometry and 3D models with solids, surfaces, and mesh objects.

Project 1:- Creat the drawing of C.S of load bearing wall over spread footing.

Procedure :

1. Open the Auto CAD software .
2. Craet a new drawing
3. Steeing up the required formate of measurement units and size of the drawing .
4. Plot the first starting point anywhere in the sheet with line tool.
5. Plot the other points follwed by the other points according to the given diagram of sketches.
6. After completing the drawing plot the dimensions.

As a result we creat all the geometries as per given sketches.

Project 2:- Creat the drawing of C.S isolated footing.

Procedure :

1. Plot the first starting point anywhere in the sheet with line tool.
2. Plot the other points follwed by the other points according to the given diagram of sketches.
3. After completing the drawing plot the dimensions.

As a result we creat all the geometries as per given sketches.

Project 3:- Creat the line drawing of a two bedroom building.

Procedure :

1. Plot the first starting point anywhere in the sheet with line tool.
2. Plot the other points follwed by the other points according to the given diagram of sketches.
3. After completing the drawing plot the dimensions.

As a result we creat all the geometries as per given sketches.

Project 4:- Creat the drawing of C.S of load bearing wall showing foundation details.

Procedure :

1. Plot the first starting point anywhere in the sheet with line tool.
2. Plot the other points follwed by the other points according to the given diagram of sketches.
3. After completing the drawing plot the dimensions.

As a result we creat all the geometries as per given sketches.

Project 5:- Creat the drawing of isometric view of steps

Procedure :

1. Plot the first starting point anywhere in the sheet with line tool isometric view mode on
2. Plot the other points follwed by the other points according to the given diagram of sketches.
3. After completing the drawing plot the dimensions.

As a result we creat all the geometries as per given sketches.

Project 6:- Creat the drawing of isometric view of gable wall.

Procedure :

1. Plot the first starting point anywhere in the sheet with line tool isometric view mode on
2. Plot the other points follwed by the other points according to the given diagram of sketches.
3. After completing the drawing plot the dimensions.

As a result we creat all the geometries as per given sketches.