Creating a Floor plan, Footing detail and Isometric view using AutoCad

c1.pdf commands:

L ENTER

0.90 ENTER TOWARDS X DIRECTION

L ENTER

0.25 ENTER TOWARDS Y DIRECTION

L ENTER

0.25 ENTER TOWARDS X DIRECTION FROM THE MID POINT OF 0.90 LINE

0.25 TOWARDS BOTH X DIRECTION FROM MID POINT.

L ENTER

0.40 ENTER TOWARDS Y DIRECTION FROM THE END POINT OF 0.25

O ENTER

OFFSET OF 0.40 ENTER TOWARDS Y DIRECTION FROM THE LAST LINE

THEN

EX BOTH LAST X DIRECTION LINE AND THEN OFFSET OF 0.05 FROM BOTH X LINES.

O ENTER

OFFSET OF 0.60 ENTER TOWARDS Y DIRECTION FROM THE LAST LINE

THEN

EX BOTH LAST X DIRECTION LINE AND THEN OFFSET OF 0.05 FROM BOTH X LINES.

O ENTER

OFFSET OF 0.05

EX ENTER FOR EXTENDING LAST X DIREXTION LINE.

THEN O ENTER

OFFSET OF 1 AND THEN EX ENTER TO MEET LAST X DIRECTION LINES TO OFFSET CORNERS.

THEN MADE A RECTANGE PF 0.30 HEIGHT NAD LENGTH OF 1.15

WITH USE OF L ENTER COMMAND

THEN MADE 3 STEPS STAIRS WITH L ENTER LINE COMMAND