Aston Martin ONE-77 Challenge-11 (Project)
DESIGNING AND MODELLING OF ASTON MAARTIN CAR USING SOLIDWORKS
Akaash Chakkaravarthy
OBJECTIVE
The main motive of the course is to get hands on training with solid work software. With adequate files provided from solid works to build an Aston martin car. The steps were followed in precisely building the car in solid work software
INTRODUCTION
SOLIDWORKS is used to develop mechatronics systems from beginning to end. At the initial stage, the software is used for planning, visual ideation, modelling, feasibility assessment, prototyping, and project management. The software is then used for design and building of mechanical, electrical, and software elements.
The car build is divided into several components and every component is built step by step using the course document provided by solid work.
DESIGN METHODOLOGY
DESCRIPTION
Several tools and features are used during the course of the project and some of them are listened below,
- Curve
- Extrude
- Revolve
- Sweep
- Loft
- Boundary surface
- Fillet
- Chamfer
- Fill
- Freeform
- Trim
Using these tools, the required model is being created.
RENDERED IMAGES
These are the different views of the car that is built.
CONCLUSION
Upon following the course and the pdf provided. The Aston martin car is built successfully achieving the ultimate goal. This course helped in providing basic understanding about solid works and the different features available with it. This will provide a very strong base for other deep venture into the software.