a new title

Models used for rayleigh taylor instability are- 1.Early time growth 2.potential flow 3.Buoyancy drag balance 4.energy budget Rayleigh taylor instability test for 3 different sizes 1.element size = 0.5 mm   2.element size= 0.2 mm 3. element size=0.1 mm A steady state approach is not suitable for this simulation because…

case 1: element size:0.005 m case 2: element size:0.002 m In case 1: temp of processor after cooling = 227 k In case 2: temp of processor after cooling =335 k  

Ahmed body is a 3D model representative of a passenger car. It helps in validating CFD codes.This is a research model. In order to verify our codes we need to compare our code with experimental data and that\'s where ahmed body is used. First setup- Maximum element size in large enclosure-100 mm  Element size in large…

For steady case and transient case simulation, below given are the images of velocity profile and pressure profile  When we look at the monitor point velocity, we see that velocity has started to follow periodic curve, and in future time it will reach a steady value which will imply solution has converged. Below are…

AIM:-To check the mixing tee efficiencyABSTRACT: Mixing tee are simple cost effective method used to provide chemical diffusion to a system.These are used in ACs.In this there are two inlets provided through which our fluid flows and one outlet at the exit.These two inlets are cold and hot inlet.INTRODUCTION:-In this challenge…

AIM:-To check the mixing tee efficiency ABSTRACT: Mixing tee are simple cost effective method used to provide chemical diffusion to a system.These are used in ACs.In this there are two inlets provided through which our fluid flows and one outlet at the exit.These two inlets are cold and hot inlet. INTRODUCTION:-In this…