Steady state simulation of flow over a throttle body

Geometery :
Geometery is imported to Converge Cfd as stl input file.

Simulation Time Parameters:

Start Time:0 Cycle

End Time:15000 cycles

Boundary Conditions:

Inlet Pressure:150000Pa

Outlet pressure: 100000Pa

Elbow and Throttle Plate: Wall Type Boundary Condition(law of wall)

Where as on inlet as Inflow other as Outflow

Material:
Air is Used as a Fluid material while simulating flow over Throttle Plate.

Mesh:Mesh Size taken is 2e-3 m in x y and Z direction where as Fixed embedding of 3 layers and scale of 2 is applied near the throttle plate boundary.

Results:

Velocity:

Peak Velocity is obtained at the throttle boundary which is around 320 m/s.whereas the lowest velocity is obtained behind the throttle plate which is due to the flow obstruction.

Pressure:

Peak Pressure is obtained at the inlet of the throttle plate while there are areas around the throttle plate which experiences the lowest pressure around 0.66 bar.

Other Results:

Total Cell count And Mass Flow rate:

Total No of Cell and Mass Flow rate plots are shown Below: