Project

Steady state simulation of Flow through elbow with throttle valve

The nature of simulation is steady state

SOFTWARES USED: CONVERGE STUDIO ,PARAVIEW

The geometry used:Here is the cut view of geometry

Steps involved:

1,Importing the geometry: Importing the stl file and cleaning up the geometry is done

2,Boundary flagging: There are 4 boundary regions for this simulation such as Inlet ,Outlet, Elbow wall ,and Throttle

3,Case setup: The following things are done in case setup

Materials assignment(air).
Simualtion time parameters(The type of solvers and time step parameters).
Boundary conditions(Inlet -Inflow,Outlet -Outflow,Wall condition for remaining two regions)
Physical model -Turbulence model(RNG-ke)Grid (a base grid of 4 mm is assigned and mesh is refined in throttle area with fixed embedding option).

4,Running the simulation in command line: The case setup is validated and input files are exported

5,Running simulation in command line:

The simulation is run in command line interface for 10000 cycles

and plotting are extracted from line plotting module in converge

Mass flow rate at inlet

Mass flow at outlet

Average velocity at inlet

Average velocity at outlet

Ship work like this
in your own course.