Solving the steady and unsteady 2-Dimension heat conduction problem

AIM OF THE PROJECT:-The aim of the project is to simulate the compressible flow in the square pipe using Converge_Studio.To study the dependence of grid size on the results.Three grid size are used 1.)dx=dy=dz=0.0002m; 2.)dx=dy=dz=0.00015m; 3.)dx=dy=dz=0.00012m INTRODUCTION: -Flow through the pipe is a common flow problem…

1.AIM OF THE PROJECT: - The aim of the project is to simulate the flow in Shock Tube using Converge_Studio. This project presents the Temperature and Pressure variation with time across the shock tube to illustrate the effect of normal moving shock wave. The concepts of Event and Adaptive Mesh Refinement are presented.…

SIMULATION OF FLOW THROUGH PIPE TO WHICH CONSTANT HEAT FLUX IS SUPPLIED 1.AIM OF THE PROJECT: - The aim of the project to simulate the air flow through the circular pipe while the heat flux is provided to the pipe across the pipe. This project also demonstrates the influence of grid size on results.The project also aims…

https://projects.skill-lync.com/projects/Prandtl-Meyer-Expansion-Wave-70315  

          Simulation of flow across the Expansion waves using Converge_Studio: - 1. AIM OF THE PROJECT: -  1.) To analyse the properties of Expansion Waves. 2.) To study the flow over the Convex Corner or across the Expansion waves/Prandtl-Meyer Expansion waves. 3.)To study the influence of…

Comparsion of different flow parameters for different simulation conditions for flow through a Circular Pipe Aim: - The aim of the project is to obtain pressure and velocity profile for fully developed flow obtained using symmetryplane boundary condition for three cases (given below) using OpenFOAM.I have tried to compare…

           (PART01) Simulation of laminar flow through a Circular pipe using OpenFOAM The aim of the current project is to simulate a laminar flow through a circular pipe.The objective is to compare the valocity profile, pressure profile and shear stress profile of the fully developed flow…

         Simulation of 1-Dimensional Flow through Convergent-Divergent Nozzle using                                            Maccormack’s Technique:-        …

Solving the steady and unsteady 2D heat conduction problem The project is about the different methods of solving steady and unsteady 2-Dimensional Heat Conduction Equation. The different methods which I have used doing this project are: 1.)Jacobi Method 2.)Gauss-Seidel Method 3.)Over-Relaxation Method STEADY-STATE 2-DIMENSIONAL…

                         SIMULATION OF FLOW OVER BACKWARD FACING STEP  1.)AIM:- The objectives of the current project are: -        1.) To simulate the air flow over a Backward Facing step using Converge Studio.       …