Plot PV diagram of Otto Cycle using MATLAB

Aim:- To find out the critical frequencies of the shaft Objectives:- To create 3D model of rotating shaft To perform frequency analysis on the rotating shaft and find out the critical frequencies. Introduction:- For a rotating shaft there is a speed at which, for any small initial deflection, the centripetral force is…

Aim:- Modelling and Simulation of flow through flowbench and obtaining a plot of lift vs mass flow rate  Introduction:-  An Air flow bench is a device used for testing the internal aerodynamic qualities of an engine component and is related to the more familiar wind tunnel. It is…

Aim:- Analysis of Centrifugal pump and to obtain relation between pressure ratio and mass flow ratio  Introduction:- Centrifugal pumps are used to transport fluids by the conversion of rotational kinetic energy to the hydrodynamic energy of the fluid flow. The rotational energy typically comes from an engine…

Aim:-To find flow over aerofoil by varying the angle of attack and find the drag force and corresponding lift force. Objective:- 1.NACA0017 airfoil to be modeled in solidworks using data from nasa site. Angle of attack is to be varied to 0,2,4,6,8,10 degree. 2.Lift and Drag forces for the corresponding angle of attack…