Performed Batch-meshing on the Hood and Fender with the given criteria and assign the non-linear material property Steel to them

Objective: Perform Batch-meshing on the following components with the given criteria and assign the non-linear material property Steel to them.

1. Hood

2. Fender

Quality Criteria:- Target Element: 5mm

S.N	Quality Criteria	Value
1	Aspect Ratio	5
2	Skewness	45
3	Warping	15
4	Taper	0.5
5	Min. Length	2mm
6	Max. Length	8mm
7	Min angle Quad	45
8	Max angle Quad	135
9	Min angle Tria	20
10	Max angle Tria	120
10	Tria %	10

Procedure: Setting up the criteria and parameters and saved the file.

Exporting the saved file using Batchmesh panel:

1. Hood:

Mid Surface:

Closer View of the mesh:

Inner Panel Extract:

Zoomed view of the mesh:

Complete Mesh of the inner extract:

Complete Hood

2. Fender:

Mid Surface of a fender:

Fender Mesh:

Element quality check used in both the model:

Mesh Flow improved using the above panel after performing batch mesh:

3. Assigned steel Material using a material card

Learned to perform Batchmach by creating own set of criteria and Parameters: