NX Bracket

https://drive.google.com/open?id=1Argm4YpeDwj0zDiFMWN7xDhQqxvbfQ-3

Bracket

Creating a bracket sheet metal design by using 2d drawing. the different features i used in the sketch are counter flange, normal cutout, break corner, bead, unbend, rebend, hole. below the procedure,

• the sketch in the XZ plane.
• created Counter flange from the sketch.
• sketch in XY plane.
• Use normal cutout by the sketch on the XY plane.
• break corner of radius 25mm.
• Break corner of radius 30mm.
• break corner of radius 60mm.
• draw a centerline for a bead on the XY plane.
• unbead the sheet metal.
• create bead by using a line created on the XY plane.
• Rebend the sheet metal.
• Create points on the XY plane by using the sketch.
• Create a hole on the XY plane by using points on a sketch.

Isometric view

Top view

side view