SolidWorks- Modeling Transmission Belt, Kickstand, Front Fender & Rear Fender

Transmission Belt-

Part Link- https://1drv.ms/u/s!AgDO7btfog2EjBYjt4iFPOblphgv

Step 1: Create a 2D Sketch based on the cross-section of the Front Fender and then use the revolve tool by specifying the angle of revolving in both the directions.

Step 2: Sketch the design of the cut-out portions at both the end sections of the front fender.

Step 3: Fillet the edges of the front fender for a smooth finish. In the appearance tab, select the painted section and under painted car select the Siena finish.

Step 4: Save the Part.

Kickstand-

Part Link- https://1drv.ms/u/s!AgDO7btfog2EjBfU8bjR53D9cTHy

Step 1: Create a 2D sketch based on the cross-section of the thick portion of the kickstand, then use spline function to draw the guideway for the loft and then finally add a plane normal to the direction of our spline.

Step 2: After creating the plane create a 2D sketch based on the cross-section of the thin portion of the kickstand and create a loft across the guide curve.

Step 3: Use the dome tool to create a curved shape at both the end sections, and then Extrude cut to create a cut near the thick portion of the kickstand so that it can be attached to the pivot. After doing so we need to create a flat spot at the thinner end of our kickstand by using the split tool.

Step 4: To create a pivot point to attach to the frame we will create a cylindrical section near our cut out of the thicker section of the kickstand.

Step 5: Fillet the edges for a smooth finish and in the appearance tab, select the chrome plate finish.

Step 6: Save the Part.

Front Fender-

Part Link- https://1drv.ms/u/s!AgDO7btfog2EjBvuri1U2AOUN820

Step 1: Create a 2D Sketch based on the cross-section of the Front Fender and then use the revolve tool by specifying the angle of revolving in both the directions.

Step 2: Sketch the design of the cut-out portions at both the end sections of the front fender.

Step 3: Fillet the edges of the front fender to eliminate sharp edge. In the appearance tab, select the painted section and under painted car select the Siena finish.

Step 4: Save the Part.

Rear Fender-

Part Link- https://1drv.ms/u/s!AgDO7btfog2EjBnAxGOHDe5fm7UW

Step 1: Create a 2D Sketch based on the cross-section of the Rear Fender and then use the revolve tool by specifying the angle of revolving in both the directions.

Step 2: Sketch the design of the cut-out portions at both the end sections of the Rear Fender.

Step 3: Fillet the edges of the Rear fender for a smooth finish. In the appearance tab, select the painted section and under painted car select the Siena finish.

Step 4: Save the Part.