Project

Mastering Solidworks User Interface

1. Transmission Belt

Important Features: Extrude, Fillets.

Procedure:

Go to file New Part
Go to tools sketch, Draw the Circle of Radius 60 and draw another circle as first
Draw the lines above and below the circles and Select one of the circles and one line and add a tangent relation by clicking on the tangent icon
Then go to tools and select the trim and trim the lines you don\'t need
Add the dimensions to the sketch and Add a horizontal relation to the lower horizontal line
Transform the 2D sketch into a 3D model
Extrude the sketch for a blind condition of 88mm, click on the sketch and make the offset of 3.5mm, then the yellow selection shows the direction of extrusion
Next is to create a fillet to all Internal feature edges of 1mm
Change the colour of the part through appearances button
Save the Part.

2. Kickstand

Important Features: Extrude cut, Dome, Loft, Fillet

Procedure:

Select the New Part
Change the name of the right plane to Midplane Kickstand
Draw the ellipse to the front plane and exit the sketch, enter dimensions to the ellipse horizontal 40mm and vertical 18mm
Select the Midplane kickstand and draw the new sketch and go to normal view
Draw the spline and connect it to the Ellipse
Select the right endpoint of the spline, hold down the Control key, click on the Coincident icon
Give the dimension to the spline
Create the new plane go to reference geometry
Draw another ellipse and pierce it
Create a solid loft
Create the dome select the blue face on the loft, change a distance to 13mm
Create another dome on another side of the loft, change the distance to 5mm
Draw a rectangle on the right plane and cut extrude by direction1&2 with through all condition
Select the new sketch and draw a rectangle and extrude it
Go to the top plane, create the circle to a top plane and Extrude it and change the blind direction unto midplane with 8mm
Create 2 fillets of radius 2mm and create face fillet of 0.5mm
Change the colour of part
Save the Part

3. Front Fender

Procedure

Create Part
Change the names of all three planes
Select Vertical Plane Front Fender and draw the 3 point arc, make endpoints of arc horizontal to each other
Draw a horizontal centerline starting at the origin of 200mm
Revolved it and make direction 1 of 5 deg and direction 2 of 130 deg
Select the Midplane and Draw the 2 lines
Drawan spline on split it on both sides by a given dimension.And fillet it.
Save the Part

4. Rear Fender

Procedure

Ship work like this
in your own course.