Mastering Solidworks User Interface

https://drive.google.com/open?id=1QuJFcHUOi2C7yToV4rtDRzKI0wBJV9oe

MASTERING SOLIDWORKS USER INTERFACE

In this challenge , I\'ve learned the cut extrude , boss extrude , split , dome , mirror entities , Some shortcuts of solidworks, sketch on different planes , Make apperance on the parts.

1.TRANSMISSSION_BELT:

STEPS:

1.Construct a line of 350mm in front plane.

2.Make an arc of radius 70mm and draw a line and make an arc of 60mm radius connect with first point.

3.click on the sketch and make a offset of 3.5mm.

4.extrude the sketch for a blind condition of 88mm.

5.Make a fillet of manual to the all 15 internal feature edjes of 1mm.

6.Make an appearance to the belt.

7.save the part.

2.KICKSTAND:

STEPS:

1.Draw an ellipse on the front plane and exit the sketch.

2.And then click the right plane and press ctrl+8 to make it normal to of the sketch.

3.Draw an ellipse from an origin of the sketch and dimension it of horizontal 202mm and vertical of 110mm.

4.click on the spline and make it control point to horizontal and dimension it of 225mm.

5.select plane in reference geometry and press ctrl+8 and sketch it.

6.draw an ellipse and pierce it.

7.And then press lofted boss with centerline parameters and make dome on both sides of 5mm&13mm.

8.draw a rectangle on right plane and cut extrude by direction1&2 with through all condition.

9.On another side make a midpoint line and split it.

10.Next make an circle on top side of kickstand and extrude it by up to next and make a fillet.

11.Save the part.

3.FRONT_FENDER :

STEPS:

1.first draw a three pont arc and dimension it.

2.offset it of 6mm and draw a line and extend the offse entities and trim it.

3.Sketch a construction line of 200mm on top plane.

4.revolve it make a direction1 of 5 deg and direction2 of 130deg.

5.Appearance it and make a sketch on top plane .

6.draw an spline on split it on both sides by given dimension.And fillet it.

7.save the part.

4.REAR_FENDER :

STEPS:

1.Draw an three point arc of dimension 364mm and radius of 290mm.

2.Offset it of dimension 6mm and draw a line and extend the offset entities and trim it.

3.Revolve the sketch and make direction 1 of 10deg and direction 2 of 140deg .

4.Now on top plane press ctrl+8 and sketch it.

5.draw an spline of given dimension and split it.

6.fillet it on all edjes with 45mm.