Define the given connectors & connector clip as an Electrical Connector or Equipment and add there necessary properties using Electrical Part design workbench in CATIA V5

AIM- Route the Wiring harness on given Car Hatch and prepare a flatten view drawing in CATIA V5. OBJECTIVE- The objective of this project is to route the wiring harness and prepare flatten-view drawing for the given car body hatch. All types of packaging rules and constraints have to be considered while routing the harness.…

  AIM- Route the wiring harness for the Bugatti V16 Engine assembly and prepare flatten-view drawing in CATIA V5. OBJECTIVE- The objective of this project is route the wiring harness and prepare flatten-view drawing for the Bugatti V16 engine. All types of packaging rules and constraints have to be considered…

AIM- To prepare a flattened-view of a previously created harness assembly OBJECTIVE- The objective of this project is to create a flattened-view for a harness assembly and then place it on the drawing sheet. It is desired that the bundles with protective coverings are represented with different visuals on the drawing…

AIM-  Route two electrical harnesses as per the given layout and interconnect them as a single harness assembly and then check for bundle continuity, bundle warnings, and then give annotations to the final harness assembly. OBJECTIVE-   The objective of this project is to first route the two Harness A and Harness…

AIM- Routing of Harness layout in CATIA V5 Electrical workbench. OBJECTIVE-   The objective of this project is to route the harness layout in electrical workbench. FIGURE A: SHOWS THE 2-D SCHEMATIC LAYOUT OF THE REQUIRED HARNESS The above figure shows the length of each wire branch and the connectors associated…

AIM-  Define given connectors & connector clip as an Electrical Connector and add their necessary properties using Electrical Part design workbench in CATIA V5 OBJECTIVE- The objective of this project is to first, download the given files from TE.com then define them as an electrical connector or equipment and…

AIM- Define Clips, back shell, and corrugated tubes with all their necessary electrical properties using Electric Part Design Workbench in CATIA V5. Objectives- There are three objectives for this project. The steps required to do them are as follows- Objective 1- Download required clip cad data & define it as Electrical…