ADVANCED MESHING OF BMW M6 MODEL USING ANSA

OBJECTIVE TO DEVELOP A SIMULINK MODEL FOR ONE OF THE ADAS FEATURE OF COLLISION MITIGATION BRAKING SYSTEM (CMBS) ABSTRACT In this project we need to develop a model based design using Simulink for the feature that the CMBS should get deactivated while the vehicle is moving in reverse direction/reverse gear. The Simulink…

OBJECTIVE To calculate natural frequency at three different load condition attain a flat ride bump oscillation for a given vehicle dimension using MATLAB scripting. ABSTRACT Ride frequency, derived straight from natural frequency, is the suspension frequency found in cars. This is how fast the suspension travels up…

Transient behavior of a simple pendulum using MATLAB The figure shows the moton of the pendulum, a bob is suspended by a massless string from a fixed point.     Let us assume, m= mass of the bob l= length of string Equation for the damped motion of the pendulum is given below          …

 OBJECTIVE To mesh the given model using the spot mesh tool, using element type tria and the element size of 1 unit. PROCEDURE STEPS TO OPEN A FILE IN ANSA Click on File Select Open Select File (FORMAT .igs/SLDPRT .ansa etc.) Click Open A translator window appears CLICK OK            …

OBJECTIVE To mesh the given pressure valve model using ANSA with various element size of 15mm 7mm 2mm   TOOLS USED DURING THE PROCESS Not function ! Not function All function Lock function Invert function Coons (Under Surface) Intersect (Under Faces) Loop function Feature Area PROCEDURE STEPS TO OPEN A FILE IN ANSA…

OBJECTIVE Clean up the Hood geometry and then mesh the geometry with the element size of 5 mm for structural analysis using ANSA ABSTRACT In this project we need to clean up the geometry of the inner panel and outer panel surface of the hood and then extract the mid-surface and perform hemming process on the mid surface…

OBJECTIVE Geometry clean-up and meshing the BMW M6 model for performig CFD using ANSA   ABSTRACT As in this project we will be meshing the BMW M6 model in the wind tunnel before meshing the geometry, it should be cleaned and all the topological errors should be rectified so firstly we need to look for all the geometrical…

OBJECTIVE To check the material properties of the rail and calcuate, the speed of sound in steel rail, time taken for the shockwave to travel the entire rail and time of sound to travel length of rail.  To edit the engine file in radioss and set the frequency of animation output to a time that will give 20 animation…

OBJECTIVE Performing 2D Mesh and Mesh clean-up of Elements using hypermesh Radioss of the given geometry Practice  Clip Repair Mounting Bracket   ABSTRACT In this project we need to clean up the geometrical errors and create a mid surface of the given geometry, perform 2D shell meshing for the structural analysis…

OBJECTIVE Geometry clean up and meshing of the Turbocharger using the TRIA element type. PROCEDURE    1. STEPS TO OPEN A FILE IN ANSA Click on File Select Open Select File (FORMAT .igs/SLDPRT .ansa etc.) Click Open A translator window appears CLICK OK As the part gets opened in ANSA, firstly it is in wire mode…