OBJECTIVE       The objective of this project is to perform geometry clenup operation,there should not be any free edges, convert all  them into refine geometry. and extract  the mid surface and clean  midsurface geometry and create the 2D mesh with given target element lengh.    …

OBJECTIVE The objective of this project is to run the base simulation and to compare the simulation results on the base setup and improved shell element properties. QUESTIONS GIVEN 1.Using the crash beam file from the previous assignment, change the run time to 55 ms. 2. Change the number of animation steps during simulation…

OBJECTIVE Create the mesh for bumper assembly having mesh size 6mm, then compare the base setup simulation results and differant kinematic condition simulation results for the Crush tube file.  Cases needs to perform in Hypermesh, Hypercrash and Radioss:- Create the mesh for bumper assembly,mesh size should be 6mm. …

OBJECTIVE Comparing seven cases of rupture plate by using material laws and also compare the energy error, mass error, simulation time and then plot different energy graphs.  SOME DEFINITIONS Elasto-Plastic Materials:- Metals like steel exhibit elastic behavior for small loads. When the load is further increased the…

OBJECTIVE:- The objective of this project is to design an American chopper using solidworks and assemble its all the parts and create a photorealistic view. INTRODUCTION:-    A chopper is a type of custom motercycle which emerged in California in 1950s.The chopper perhaps the most  extreme of all custom…

OBJECTIVE: Objective of this project is to check and create the properties for a neon frontal crash model. These are the recommended checks performed in the model:- 1. Check unit system and either follow[Mg mm s] or [Kg mm ms]. 2.Create appropriate interface ,friction 0.2 and recommended parameters. 3.Make sure of no penetrations…

OBJECTIVE:- The objective of this project is to design different parts of  Sunseeker Predator Yacht using Solidworks and assemble all the parts together and create a realistic view using Solidworks Visualize. INTRODUCTION:- A Yacht is a larger,recreational boat or ship used for pleasure or sports.The word comes from…

OBJECTIVE    The main objective of this project is creating the 2D  meshing of the Housing and Arm Bracket and then finally to 3D meshing  Tetra mesh and Hexa mesh having target element size is 5mm, Hexa size 10mm, tet collapse is 0.15 . As well as we will solve some numerical problems by taking datas…

OBJECTIVE: The main objective of this challange is to set all the pre processing parameters for the simulation in the given model. then run it into the RADIOSS solver and get all the desired output request. These are the recommended checks performed in the model:- 1. Check unit system and either follow [Mg mm s] or [Kg…

OBJECTIVE: The main objective of this challange is to set all the pre processing parameters for the simulation in the given model. then run it into the RADIOSS solver and get all the desired output request. These are the recommended checks performed in the model:- 1)Set the impactor above the car. 2)Set Boundary conditions.…