Objective - Meshing a model using surface mesh as taught in lecture 0.5 and 1. Procedure - 1) Importing the file -import the file that is given (in my case its a .sld file).nothing to do with the translater window, click ok. 2) Setup the display -use shadow mode to make the object look like from wireframe structure to…

Objective: To create connectors and attach various parts of the given model with them. Observation:-The given part is a frame assembly. -The type of connectors which are give to attach are shown in the picture below: Procedure: 1) Import the file in import browser in hypermesh. *open the profile in Optistruc and not radioss.…

Objective: Mesh the given models with the respestive alloted mesh type and quality critria. Observation:a) create tetramesh for mode l (housing.stp)b) create 3D mesh for model 2 (crank housing)c) create 3d mesh for model 3 (chassis assembly) Quality criteria : target element length sizes: 5mmminimum length size : 2mmmaximum…

Objective: to mesh the given model with the given quality criteria specification. Observation: the given model is a car hood which has four different parts.The four parts are:inner hood x1outer hood x1latch x1hinge x2 The given quality criteria is shown in the picture below: Procedure : 1) I checked for any topological…

Aim: Meshing the Turbocharger Model Procedure:  1) Getting started Importing the file and Setup the display - import the file that is given (in my case it’s a. ansa file). In the translator window, select ‘cfd’ option since the meshing is done for the CFD application purpose. Use shadow mode to make…

Objective: To mesh the given model with batch meshing and the given quality criteria specifically and assign Non linear material property id\'s to them. Observation: 1) the given model is a car hood pannel which has four different parts. It is a sheet metal model with uniform thickness of components through out the area.…

Objective: to create 1D elements on the given component \"parallel bracket\", with given cross section and degree of freedom. a. Rod element- with only translational DOF and RBE2 linkCross-section: Box- Dimension a=12mmdimension b=10mmthickness t=0.75 b. Beam element- with all DOF and RBE3 linkCross-section: I section-…

Objective: To perform geometry clean up and mesh operation on the given three models with the given quality criteria specification. 1)            Practice 2)            Clip repair 3)            Mounting…

Objetive: To answer the questions that were asked in the challenge.   Questions: 1) Check the material properties of the rail component and calculate the speed of sound in steel rail. Ans. * The material properties of the rail component as seen from the "engine input file" that is -" FIRSTRUN_0000.rad "  = are…

Objective : To Compare results with base simulation and improved shell element properties Procedure:  1)  Using the crash beam file from the previous assignment. Import file in hypermesh through the import solver deck menu. In the Model browser navigate Cards menu and click on the ENG_RUN (card image).…