Week 8 - Challenge 3 - Coin Holder Design

I am created with the COIN HOLDER drawing , So Note them is CLASS A, AXIS LINE , CLASS B and CLASS C

Created .

NOTE:

First of all the created the Tooling diraction ,Tooling axis create with the selected the surface use the point future, And the next step line future select the point with diraction.

And then created with the B- surface select surface extaract and untriming action ,extrapolate next step for trim future side by side. first side wall, top wall,outer flange And Initial trims

Next step of c-surface ,The use with sweep commend , c-surface is A+C+B joining operation go for part design so use with the close surface future and then last future is draft analysis, But draft analysis degree is 2.9 or 3