Challenge

Week 8-3D Tetra Meshing Challenge

Model 1:-

Objective:

To generate Tetra mesh for the given housing componentfrom 2D to 3 D conversion.

Procedure:

First input the housing model and start to clean up the model.
After cleaning the model, go to automeshing part and give the Elements sizes: Min- 2 Units, Target- 5 Units, Max- 7 Units .
Next mesh it.
After meshing if there are anu geometric errors clean the quality criteria.
Next go th 3D pannel and give the mesh parametrics and tet-collapse as 0.15.
Now mesh the model with tetra meshing.
Make sure the mesh is in trias and the model is fixed.
Then save the model.

Result:

The given housing model is meshed from 2D to 3D.

-----------------------------------------------------------------------------------------------------------------------------

Model 2:-

Objective:

To generate a 3D tetra mesh for the given component.

Procedure:

View - Brousers - Hyper mesh - Utility

Utility - Geom. Mesh - Quick tetra mesh

Now select the components and start to select the components and select the parameters.
Now quick mesh the component.
Check for tet collapse, if there are any tet collapse please clean the geometry by remeshing it.

Result :

The above model is tetra meshed.

-------------------------------------------------------------------------------------------------------------------------

Model 3:-

Objective:

To generate a 3D tetra mesh for the given Turbo charger component.

Procedure:

View - Brousers - Hyper mesh - Utility

Utility - Geom. Mesh - Quick tetra mesh

Now select the components and start to select the components and select the parameters.
Now quick mesh the component.
Quick mesh each of the component separately.
Check for tet collapse, if there are any tet collapse please clean the geometry by remeshing it.

Result :

The above Turbo charger model is tetra meshed.

-------------------------------------------------------------------------------------------------------------------------

Ship work like this
in your own course.