Week 7 Challenge - Assembly Workbench

ASSEMBLY WORKBENCH CHALLENGE

FIRST IN THE START MENU I SELECTED ASSEMBLY DESIGN.

LATER I TOOK PART BY DEFINING PART COMMAND IN THE PRODUCT STRUCTURE TOOLS BY SELECTING THE PRODUCT,(PRODUCT IS SELECTED BECAUSE THE PART EXISTING IS DIRECTLY INSERTED IN THE PRODUCT).

NEXT I DOUBLE TAPPED THE PART WHICH EXISTED NEWLY.

NOW THE WORKBENCH IS DIRECTLY MOVED OR SHIFTED TO THE PART WORKBENCH.

IN THIS PART WORKBENCH I CREATED POINT AND AXIS IN THE SEPERATE GEOMETRICAL SET NAMED AS GEOMETRICAL SET 1.

NEXT, IN THIS GEOMETRICAL SET I DRAW THE SKETCH OF THE BODY-1 BY USING SKETCHER TOOLS.

AND THEN I CONVERTED THE SKETCH INTO THE SOLID BODY BY USING PART TOOLS IN THE PART WORKBENCH.

SIMILARLY I DID THE SAME STEPS UNTIL THE PART EXISTS BY TAKING SEVERAL PART BODIES SEPERATELY.

AFTER COMPLETION OF FULL PART WITH SEVERAL BODIES LIKE (BODY 1,BODY 2,BODY 3.... OR BY NAMING THE PARTS) I SHIFTED INTO ASSEMBLY WORKBENCH.

AND I DID ASSEMBLY OF ALL BODIES TO GET A SINGLE PART OR SINGLE PRODUCT BY USING SEVERAL CONSTRAINTS LIKE COINCIDENCE CONSTRAINT, CONTACT CONSTRAINT, FIX COMPONENT, ETC.

THESE ALL COMMANDS ARE AVAILABLE IN THE CONSTRAINTS COMMANDS.

FINALLY, I SAVED THE PRODUCT USING SAVE MANAGEMENT.