Week 12:Project 2-Meshing of Rear Wheel Holder challenge

Objective:

To mesh the given component with the given quality criteria.

Procedre:

• Import the given componebt
• Now clean up the geometry by using,
  • Toggle,
  • Replace,
  • Filler,
  • Ruler, commands.
• After cleaning up the geometry now try to take the mid surface for the geometry.
• Use auto mid surfacing command, to take midsurface.
• Now toggle & untoggle the unwanted surgaces in the mid surface.
• Now 2D mesh the given mid surface.
• Apply the given quality criteria,

• Target Element Length = 5 Units

  S.N	Quality Criteria	Value
  1	Aspect Ratio	5
  2	Skewness	45
  3	Warping	15
  4	Taper	0.5
  5	Min. Length	2 Units
  6	Max. Length	8 Units
  7	Min angle Quad	45
  8	Max angle Quad	135
  9	Min angle Tria	20
  10	Max angle Tria	120
  10	Tria %	10

• Now save the model.

Conclusion:

The given model is geometry cleaned, midsurfaced, meshed and quality checked with the given quality criteria.