Week 11 - Final project

REPORT FOR THE FINAL PROJECT

Class A surface

this is the surface already given by th technision and surves of the master section is already given by the technision

tooling axis

first i have to extract the surface from the A surface then create a point in between the surface then creat line on point on y direction

class b surface

create the offset of the a surface 2.5 mm thn which surface is not offset we have to repair with the help of master section

and then extrapolate and trimming

draft surface

we have to create boundary and and which surface we have to create down direction take sweep with draft direction pulling downward with 3 deg

and othe surface we have to take with refrence surface with 90 degree and for joing we to extrapolate the edges and then we have to trim command and all the draft surface will e created

class c surface

now we have to joing the draft surface and class a surface and now we have to extra polate the class b surface and check it with the intersection if the black dot didint appear that mean ther is no error and then uss the trimm command and select both and trim and now c surface is created

First all the part model is created with the help of part design circle comand and and for every part saperate all the model are created in saperate file then we have to create assembly workbench then there will existing part comand with the help of command bring all the part in file

Then with the help of part comand one fix axis we have to create and create axis line and fix it and then fix this axis with the unmovable part and make constrain both the points and then for every model we have to create axis line with the help of circular obsject so we can coincidce with the othe other axis

Then every part we have to arrange it as shown in images and contrain it and give different colour to object so it can be easily identify

Same procedure i have followed for the second challenge

And i have upploaded the folder as part 1 and assembly 1 and part 2 and assembly 2 where in part all the part model files are available and assembly the assembly files are available

create dog house

then first extract the matersection and join the by line surface then create

surface with the extrude then thne measure with the help of intersection and with the help and extrude and trim comant make the exact measurment of the dog house snf then measure it and then create body and use thickness surface of 2.5 mm and thne kept the fillet of with the help of measurment and then apply it . then take the master section of rib and then pad it with it and then union trim with the dog house and then we have to union trim with the pillar master section

now create the sphere of 5R and then diagnol line of 45deg

then after the flanges has to be created with help of master secction in opposite part part and master section is required

for joinining the all the class c surface

after it in every place were dog house and heat stakes are created we have to give fillet of 0.25 mm

and at last we have to constrain the push pin on up of the dog house