Reinforcement Detailing of Beams from ETABS output

Aim:- To design the beams in detail from the Etabs 2018.

Procedure:-

Step:-1

First we have to open the challange 7 page and download the challenge.

After downloading the Challenge open it in the etabs 2018, as shown below.

Step:-2

Next we have to check the load combinations, as shown below.

Step:-4

After the completion of the beam design, we need to select the 'Display Design Info' option, as shown below.

After selecting the 'Display Design Info' option the new tab appears, In that we select the Longitudinal Reinforcing in the Design Output and click on the OK button, as shown below.

Next we need to draw the Reinforcement diagram of 7 span continous beam along Grid-3, and also need to provide the reinforcement details.

The maximum Ast for the bottom support is 1061mm2

and bottom middle is 1493 mm2The maximum Ast for the top support is 1915mm2

and top middle is 479 mm2

Next the Shear details will be visible, as shown below.

As per the clause 6.3.3 the design force is 232 kN.

We got, Maximum Shear force = 174.11 kN.

RESULT:-

The beams are designed successfully in detail from the Etabs software.

Provided the details of longitudinal and shear reinforcement for the two continuous beams.

And also calculated the value of maximum shear force in the continuous beams using the Etabs software.