Fender Design - Wheel Arch Challenge

FENDER WHEEL ARC

1. A Horizontal and vertical axis is drawn from the centre of the wheel.
2. The vertical axis intersection point is labelled as A.
3. Similar references are drawn at 30 degrees to left and 50 degree to the right and named it as B and C respectively.
4. A line of 150mm is drawn perpendicular to the horizontal axis and normal from the normal point on fender which gives point E.
5. The midpoint of the arc cut by the sections C and E results in a new section D.
6. The value of 'L' at each section and the value of 'a 'are found out to detrmine whether the fender satisfies the european standards as shown below.

   LINES	REGULATION	CLEARANCE	RESULT
   SA	10MM	9.94MM	FAIL
   SB	10MM	10MM	PASS
   SC	10MM	0.11MM	FAIL
   SD	10MM	5.99MM	FAIL
   SE	10MM	2.88MM	FAIL