Creation of geometries by Coordinate system methods using AutoCad

A] Now we draw the given drawings using the co-ordinate system methods in autocad. And that should be drawn and discussed in detail.

• AIM:

(A) Create the geometries from P1 to P2 using all the coordinates system methods. And we need to use line tool, and find the missing dimensions.

(B) Civil related problems- Draw the profile and the trusses using any coordinate system methods. The dimensions are there for references.

• Introduction:

Before going to the drawing we should know about the coordinates systems.

In Autocad there are two coordinate systems: Cartesian and polar.

To these coordinate systems the absolute and relative coordinates of Autocad as are applicable.

Also coordinates in AutoCAD can be set by mouse, input (setting) the values ​​of coordinates in the command line and enter coordinates using dynamic input.

There are three types of co-ordinate systems.

1. Absolute coordinate systems

2. Relative coordinate systems

i. Relative rectangular coordinates

ii. Relative polar coordinates

3. Direct distance entry

Commands used:

1. Line command

2. Dimlinear command

3. Text command

4. Circle command

• Procedure:

(A) Create the geometries from P1 to P2 using all the coordinates system methods. And we need to use line tool, and find the missing dimensions.

Absolute cooardinate system:

P-1 drawing:

Below we have drawn the P-1 drawing using the absolute coordinate system,

DRAWING- 1

DRAWING-2

DRAWING-5

drawing-4

drawing-7

drawing-8

drawing-9

drawing-10

drawing-profile wood

queen post truss

mono pitch