Creating Bar Bending schedule, Different Door types, and Creation of standard drawing templates using AutoCad

AIM:

To Create Custom1_titleblock and Custom2_titleblock using Attributes and block command from Autocad software .

PROCEDURE:

Step 1 ( custom1_tittleblock)

• In the command prompt type L to draw the lines
• In ribbon tab > Annotate > Mtline ( to draft the text )
• go to properties tab to change the colour
• In the riibon bar >block > create block and name it Custom1_titleblock.Therefore the block is created

• STEP 2 (custom2_tittleblock)

  • In the command prompt type L to draw the lines
  • In ribbon tab > Annotate > Mtline ( to draft the text )
  • go to properties tab to change the colour
  • In the riibon bar >block > create block and name it Custom2_titleblock.Therefore the block is created

• 2. Create the doors type for warehouse as shown in the Figure. You need to create each door type as per
  standard size or given dimensions. Create the blocks of this door type after creating them.

  AIM:

  To create the doors type for warehouse and to also create the block of this door type after creating them using AutoCAD

  PROCEDURE:

  step 1:

  • In the command prompt type the units > mm
  • In the command prompt type the limax > 100,100
  • In the command prompt type the limits >0,0

  step 2 :

  • In the command prompt type l to draft the lines
  • In the command promt type rec to draft the boxes or rectangle
  • In the command prompt type fillet to get the curve edges
  • In the ribbon bar > dimensions ( to give the dimensions of the door )
  • In the ribbon bar > annotation > text ( to give the text for the door )

  • step 3 :

    • In the command prompt type l to draft the lines
    • In the command promt type rec to draft the boxes or rectangle
    • In the command prompt type fillet to get the curve edges
    • In the ribbon bar > dimensions ( to give the dimensions of the door )
    • In the ribbon bar > annotation > text ( to give the text for the door

  • 3. Create each symbol as a block with the name given in the legend. After creating the blocks arrange
    them in the legend as shown in the Figure.

    AIM:

    To create each symbol as a block with the name and then arrange them in the legend

    PROCUDER:

    • In the command prompt type C to get the circle
    • In the command prompt type L to get the lines
    • In the ribbon bar > annotation> Multiline text
    • In the command prompt type l to draw the lines
    • In the command prompt type arc to draw the arc
    • In the command prompt type Mtext
    • In the ribbon bar > block>create block
    • n the command prompt type l to draw the lines
    • In the command prompt type Mtext
    • In the ribbon bar > block>create block
    • In the coomant prompt type I to insert the blocks