Creating a Floor plan, Footing detail and Isometric view using AutoCad

Aim & Introduction: Creating Floor plan, Footing detail & isometric view using autocad.

Procedure :

• C1: In drawing C1, line tool was used to create a height of 0.25mm & length of 0.90mm. All the dimmensions are in milimeteres. Then offset was done from line 0.25 at distance of 0.90 and from 0.90 to 0.25. After that vertical offset was taken from 0.25 to 0.2 m from both the ends and using the trim tool the line was cut. After that the line of 0.40 in vertical distance was done from the ends with the length of 0.50. As per the drawing. like this the entire drawing was created.