Week 6 Challenge

Objective:
To extract midsurface, mesh and assign thickness to the component acording to the given criteria.

Procedure:

Imported the solid model and deleted all solids, leaving behind surfaces.
There were 5 components, extracted midsurface for each of the components.
Then meshed each of the 5 midsurfaces, one at a time. First meshed the latch, then hinges, inner body and outer body.
After every mesh, used check elems option to confirm that the elements are within the quality criteria.
When meshing midsurface out hinges , inner and outer body, one side was meshed and reflected for uniformity, as the surfaces were symmetric.
When the meshing was done for all 5 ccomponents, assigned thickness of 2.5mm to each. Also assigned material and property to each.

Result:

The given component was meshed according to given quality criteria and assigned thickness to the components\' midsurface.