Project

Meshing of cylinder

Meshing of cylinder in following steps

First select the clyinder file
Then select the PID mode from draw mode.
Did geometry checks for error finding, after that click on cross hatches.
Then in \'faces\' click on setPID, select the faces/shells then select the face of clyinder click milddle mouse button then give name to face by selecting \'new\' and give name to face like Wall. Do same for all faces and gives names like inlet, top and bottom of cylinder.
After that select the mesh mode and select the lenght form \'perimeters\' and select the perimeter now select whole cylinder press middle mouse button a new box popup enter the 1 unit in length.
Then select the spot meshing from \'mesh generation\' then go in option list which is at bottom on right side cornor select \'tria\' then select the whole cylinder and press middle mouse button.
Mesh is applied to clinder.
Now run surface mesh for error.

To see mesh cylinder file.

quads: 0

trias: 604640

total: 604640

Ship work like this
in your own course.