Hypermesh Report on - Performing batch Meshing on Sheet metal object

Hypermesh Report on: -

Performing batch Meshing on Sheet metal object.

__________________________________________________________________

Aim: To Create 2D batch mesh on hood and fender surface in HyperWorks.

Model - 1

Process:

• We have to mesh this given Hood model with the target element size of 5mm.
• We also have to follow the below-mentioned quality criteria, mesh the component given below and assign thickness.

• We will start Batch meshing with the outer surface of the hood.
• As we can see the hood surface is exactly symmetric to the other side.
• We will use the reflect option to reflect the symmetric mesh on the other side.

• We follow the same steps here as well for inner hood panel batch meshing and reflecting it.
• After reflecting we do the quality check and assign thickness.

• So in this way completed our hood meshing with quality check and thickness 0.75 assigning.

__________________________________________________________________________

Model - 2

Process:

• We have to mesh this given fender model with the target element size of 5mm.
• We also have to follow the below-mentioned quality criteria, mesh the component given below and assign thickness.

• We will start Batch meshing with the fender.

• So in this way completed our fender meshing with quality check and thickness 0.75 assigning.

__________________________________________________________________________

Conclusion: In This report we understood the batch meshing of complex geometry and thickness assigning process.

__________________________________________________________________