Design 3D Chopper Parts - Rear Wheel Front Fork - By Vinayak

1. Rear Wheel (Spider Webbed Rims):

https://drive.google.com/open?id=1KfkR5fgx-15sje1cUE4KmDXk4YJoHYcf

Commands/ Tools used while Designing Rear Wheel of Chopper:

This 3D Model for the Rear Wheel (Spider Web Design) was created by using tools as mentioned below:

1. Revolved Boss/Base - To create Tires

2. Extrude Boss/Base - To create the Rims, Calipers, Rotor, Sprocket viz.

3. Extruded Cut - To remove the additional material from the extruded rims to create spider webbed Design and also for the cut out from the sprocket and rotor.

4. Cut Revolve - To cut out the side sections from the extruded Rims for the spider webbed Design

5. Circular Pattern - To create circular patterns in the sprocket, Rotor, Rims, Tire Grip design.

6. Appearance - To specify the materials of various parts.

2. Front Fork:

https://drive.google.com/open?id=103L2CLblMkqPR-0A5NvQbuVNTxCnFbue

Commands/ Tools used while Designing Front fork of the Chopper:

This 3D Model for the Front Fork was created by using tools as mentioned below:

1. Revolved Boss/Base - To create Fork Tube, Hand Grip, Head Light viz.

2. Extrude Boss/Base - To create the Triple Clamps, Brakes viz.

3. Extruded Cut - To create circular cutouts for the Triple clamps.

4. Dome Tool - To create the dome shape of the Headlights.

5. Linear Pattern - To create the two portions of the triple clamps.

6. In addition to the above commands to create the complex shape of the Bike Handlebars & the Brake Wires, Projected Curve was used to create the path for the sweep command and then the sweep tool was used from the feature tab to complete the Bike Handlebar, the same procedure was used to design the brake wires.

7. Appearance - To specify the materials of various parts.