Creating different types of 1D elements using hypermesh

Objective - Meshing of the hood according to the given quality criteria using Hypermesh Target Element Length = 5mm S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5 5 Min. Length 2mm 6 Max. Length 8mm 7 Min angle Quad 45 8 Max angle Quad 135 9 Min…

Objective:- To Create 1D elements on the following component with given cross-section and DOF for the below-given component Rod element Beam element Bar element Spring elements Rod element: Rods are basically used for tension and compression. In certain softweres also used for rotation as well. Beam element A beam element…

                         BMW M6 MESHING - ANSA The objective of this project is to perform meshing for a given BMW M6 exterior model using ANSA. The model is cleaned and checked for errors, then using the given element size, is meshed accordingly. For any…

                                 CFD Meshing of Pressure valve using ANSA Objectives: To clean up the given topology of pressure valve model using ANSA To mesh…

       Advanced CFD Meshing of Turbocharger using ANSA Objectives: To clean up the given topology of turbo charger model using ANSA. To mesh the given model using proper meshing tools. To generate volumetric mesh for the given turbocharger Procedure: Generating mesh for any geometry is a two…

                        Meshing of a cylinder using ANSA Steps to followed: Import the CAD model Display setup Geometry check up Creating the PIDs Defining the Element size or length selection of meshing type…

           Roof crush test on Dodge Neon BIW using hypermesh and Radioss Objective: To simulate a roof crush test on a Dodge Neon BIW, as per FMVSS 216 standards, and determine the roof crush resistance of the model. Geometry Cleanup and Assembly: The meshed model of the…

           SIMULATION OF SIDE CRASH POLE IMPACT ANALYSIS OF NEON BIW   To simulate the side crash analysis of neon BIW is by creating a cylindrical rigid wall on the side of B-Pillar. The distributed mass of 700Kgs is created to move the COG of model at the middle…

   SIMULATION OF FRONT CRASH ANALYSIS OF NEON BIW    To simulate the frontal crash analysis of neon BIW is by creating a rigid wall infront of the bumper to impact. The distributed mass of 700Kgs is created to move the COG of model at the middle and near to driver's area. Finally the simulation is Pre-Processed…

This assignment is about analysing the model with different kinematic conditions and comparing the base simulation files. The file includes the crash tube against rigid wall , one end of the tube(rear end) has defined boundry conditions and nodes are constrained.we have master node of 500kg . The properties of the materials…

CASE 1:                                       Law2_Epsmax_failure: As per the instruction i opend the file from solver deck (FAILURE_JHONSON_0000),…

1.Using the crash beam file from the previous assignment:   The base simulation file is taken from the previous assignment and changed the Run time into 55. import solverdeck and edit the file run time into 55 m/s (no need to mention the units while giving the values) 2. Changed the number of animation steps during…

Step 1: Cleaning the geometry . opened the model files .hm for the geometry cleaning. For visualizing the errors ,I have used the visualization option(visualization=errors) Delelted the unwanted lines by using delete option . whic it is available on the bar. Toggled the edges by using toggle option on quick edit panel.…

                   ENGINE FILE EDITING AND 3D MESHING 1.Speed of sound in steel Rail:      speed of sound =√E/R                         …