A codes to perform curve fitting by using different equations and to determine the best fit according to given Temperatuer and Specific heat data

Objective - Simulate the flow over a cylinder  Theory Reynolds number:-  Ratio of internal force to viscous forces  It is dimensionless number  helps predict flow patterns in different fluid flow situations.  At low Reynolds numbers, flows tend to be dominated by laminar (sheet-like) flow, while at high Reynolds numbers…

student_marks=[20,40,30;80,40,30;52,75,95]

Objective:- MATLAB code to calculate the Thremodynamic properties of different species from given NASA Thermodynamic data by using the concept of File Parsing.IntroductionParsing a file means reading in a data stream of some sort and building an in memory model of the semantic content of that data. This aims at facilitating…

OBEJCTIVE:- Write a MATLAB Program to optimize the given stalagmite function using Genetic algorithm. INTRODUCTION OF GENETIC ALGORITHM(GA). - genetic algorithm (GA) is a process of natural selection that belongs to the larger class of evolutionary algorithms(EA). - It is based on the concept of Darwin\'s theory…

Objective- Write a Matlab codes to perform curve fitting by using different equations and to determine the best fit according to given  Temperatuer and Specific heat data.   What is Curve Fitting Curve fitting is the process of constructing a curve, or mathematical function, that has the best fit to a series…

objective = To write a program that solves the following ODE. This ODE represents the equation of motion of a simple pendulum with damping In the above equation, g = gravity in m/s2, L = length of the pendulum in m, m = mass of the ball in kg, b=damping coefficient. Input Values L=1 metre, m=0.1 kg, b=0.05. g=9.81 m/s2.…

Objective- To simulate Air Standard Cycle(Otto-cycle) by creating PV diagram and to calculate output thermal efficency and work done by using MATLAB. Theory- Process of Otto cycle process 1-2 isentropic compression process 2-3 constant volume heat addition process 3-4 isentropic expension process 4-1 constant volume heat…

Objective- Program for analysis of data, Using an Input IC-engine Data file. import math import matplotlib.pyplot as plt import numpy as np # values crank=[] pressure=[] temperature=[] volume=[] # File Parsing for line in open(\"engine_data.out\"): if \"#\" not in line: value=line.split() crank.append(float(value[0]))…

Objective- Write a codes to perform curve fitting by using different equations and to determine the best fit according to given  Temperatuer and Specific heat data 1. What does popt and pcov mean popt=a arrat with the best estimated values for the coefficients  in the equation.          example-…

Objective- determining the minimum cushion pressure needed to break a given thickness of ice with Newton Raphson Method. using an air cushion vehicle, Muller (“Ice Breaking with an Air Cushion Vehicle”) inMathematical Modeling: Classroom Notes in Applied Mathematics, SIAM 1987) derivedthe equation where p denotes…

objective = To write a program that solves the following ODE. This ODE represents the equation of motion of a simple pendulum with damping In the above equation, g = gravity in m/s2, L = length of the pendulum in m, m = mass of the ball in kg, b=damping coefficient. Input Values L=1 metre, m=0.1 kg, b=0.02. g=9.81 m/s2.…

Objective- To simulate Air Standard Cycle(Otto-cycle) by creating PV diagram and to calculate output thermal efficency and also creating curve between thermal efficency with respect to compression ratio. Theory- Process of Otto cycle process 1-2 isentropic compression process 2-3 constant volume heat addition process 3-4…