Solving second order ODEs Aim Write a program to simulate the transient behaviour of a simple pendulum and to create an animation of it\'s motion. Introduction A pendulum is a weight suspended from a pivot so that it can swing freely. When a pendulum is displaced sideways from its resting, equilibrium position, it is subject…

Genetic Algorithm Aim Write a code in MATLAB to optimise the stalagmite function and find the global maxima of the function.  Introduction Genetic Algorithm (GA) is a search-based optimization technique based on the principles of Genetics and Natural Selection, in line with the Darwinian Theory…

Internal Geneva Mechanism   Aim To create the 3D model of the internal Geneva mechanism, to perform motion analysis by rotating the driver wheel at 10rpm, 20rpm and analysing it by plotting different variables. Objectives To create 3D models for driver and driven wheels. To perform motion analysis by rotating the…

Modelling and Analysis of Planetary Gear using Solidworks  Aim To model and analyse planetary gear system in Solidworks. Objectives Model a Ring Gear with Module = 2.5 , Number of teeth = 46 Model a Sun Gear with number of teeth = 14 Calculate pitch diameter and number of teeth for planet gear and model them Design…

MBD Simulation on a Piston Assembly 1. Aim Model all the parts of a piston assembly and perform the motion analysis in different conditions. 2. Objectives   1. Performing Motion Analysis of the Piston Assembly in given below condition of the piston.       Note: Crank rotation is in the…

MBD Simulation on IC Engine Valve Train 1. AIM  To model & assemble IC Engine Valve Train and perform motion analysis of the assembly 2. OBJECTIVES Model the parts and assemble them in SolidWorks.  Run the simulation using the below parameters Sl.No CAM Lift (mm) Speed (RPM)  Material  1 3.5 1500…

1. AIM To model the flow over NACA0017 airfoil and compare the lift and drag force for the angle of attack 0,2,4,6,8,10. 2. OBJECTIVES Import NACA0017 airfoil from coordinate data text file. Model NACA0017 Analyse flow simulation of airfoil for different angle of attacks from 0 to 10 with an interval of 2. Compare lifts…

1. AIM To model and simulate flow through a flowbench and analyse the results. 2. OBJECTIVES Create a 3D model of a flow bench. Run flow analysis. Plot lift vs mass flow rate. Run Grid dependence test. For three grids run simulation at a particular valve lift and explain your results. Effect of valve lift on mass flow…

1. AIM To design and analyse a Centrifugal Pump. 2. OBJECTIVES To create a 3D model of a centrifugal Pump. To obtain the relationship between Pressure ratio and mass flow rate (Performance diagram.) 3. INTRODUCTION A pump is a device that moves fluids (liquids or gases), or sometimes slurries,…

 1. AIM Simulate the flow over a cylinder for different conditions 2. OBJECTIVES Calculate the Reynolds number for a particular velocity. Then increase the Reynolds number by a factor of 20%, 40%, and 100% then run the transient flow simulation. Create animations for pressure-velocity for all the three Reynolds…

1. AIM Find out the critical frequencies of a rotating shaft in Solidworks by conductiing frequency analysis. 2. OBJECTIVES Create the model in Solidworks. Conduct a frequency analysis and apply a bearing fixture on the stepped face of the rod at the two ends and perform the analysis. Find out 5 mode shapes and list the…