Jacobi Method:Jacobi iterative method is an algorithm for determining the solutions of a diagonally dominant system of linear equations. Each diagonal element is solved for, and an approximate value is plugged in. The process is then iterated until it converges. Let be a square system of n linear equations, where:…

Aim: Python program to obtain the presssure-volume curve of a otto - cycle. Introduction:   Process 1-2 a mass of air is drawn into piston/cylinder arrangement at constant pressure. Process 2-3 is an adiabatic (isentropic) compression of the charge as the piston moves from the bottom dead center (BDC) to…

AIM: Create a Rankine Cycle Simulator  OBJECTIVE:  Calculate each state points of the Rankine Cycle  based on  inputs.  Plot the corresponding T-s and h-s plots for the given set of inputs. Calculate Efficiency. The Rankine cycle is an idealized thermodynamic cycle of a heat engine that converts…

Aim: Program to simulate the transient behaviour of a simple pendulum and to create an animation of it\'s motion. Introduction: A simple pendulum consists of a ball (point-mass) m hanging from a (massless) string of length L and fixed at a pivot point P. When displaced to an initial angle and released, the pendulum will…

Aim:Program to perform curve fitting in PYTHON Questions asked: 1. What does popt and pcov mean?  Popt = An array that holds the value of the coefficients of variables in a function. Pcov =  Is an two dimensional array that stores the values of the estimated co-variance of popt i.e  the coefficients …

Aim: To simulate the internal Geneva mechanism for the given condition and plot the graph Objective: Prepare 3-D model driver and driven part of internal Geneva mechanism.  Create the assembly of a Geneva mechanism. Simulation of the Geneva mechanism at 10 and 20 RPM Compare the graph for the precise contact and non-precise…

Objective: The main objective is to model and assemble IC engine valve train which consists of essential parts such as a cam, push rod, rocker arm, valve mount, and valve  and  run the motion analysis to find the contact force encountered between the parts and  explain the results. Introduction: A valve…

Objective:            To create a 3D model for Piston Assembly and parts are performed a motion analysis and also to study linear displacement of the Piston head assembly. Introduction: A piston is a component in reciprocating pumps, engines, gas compressor, and other similar mechanisms. It…

Objectives: To find out the critical frequencies of a rotating shaft in Solidworks by applying a bearing fixture on the stepped face of the rod at the two ends and perform the analysis. Rotating Shaft Design: Boundary Conditions: Material - Alloy Steel The stepped ends of the shafts were fixed by bearing fixture.…