Introduction Two cases of plates are taken, an FEA Simulation is carried out on them to find the values of stress, strain and displacement. Then the best case is chosen out of the two   Objectives The objectives are:- To find stress, strain and displacement value for case 1. To find stress, strain and displacement…

  Introduction A rotating disk with a stepped shaft is mounted on a bearing. In this scenario there will be certain frequencies at which the entire assembly of disk and shaft will experience resonance with characteristic mode shapes.   Objectives To find the mode shapes and the corresponding resonant frequencies…

Introduction In this study a cyclone separator stand is tested for its buckling factor of safety using SolidWorks, then subjected to a design study to ascertain the optimal distance where a stiffener is to be placed to maximize the buckling factor of safety. Finally, the results of the design study will be verified using…

Report Conditions of benchmarking: 1. Bangalore is described as a highly crowded city, hence car size cannot be excessively large.Hence Cars below 4000mm of length are considered(with two exceptions namely,Toyota Etios and Nissan Sunny because of customer\'s preference for big cars) 2. Due to congestion, repeated starts…

INTRODUCTION An automobile fender will be designed in this project guided by a master sketch.   Master Sketch   Details Thickness = 0.75mm Bolt Size : M8   RESULTS   Overall View   Bumper Mount   A-Pillar Mount   Drip Area   Wheel Arch Mount   Sill Mount   References The…

Introduction Three different cases of beams are taken of three different cross-sectional profiles, namely – rectangular, I-section and half I-section. A force of 1500 kN is applied on the smaller face of the beam, uniformly.  The length of each beam is 400m. The finite element analysis of each beam are carried…