https://drive.google.com/file/d/1_K76usfF0lsc9CQSLV50Z82vCLZSaTJN/view?usp=drivesdk

https://drive.google.com/open?id=1QHnzCC33cuarTKqLSvu_-1MnrtVluTms     the link for the PDF

Comments by Grader:1. Good job2. Publish the report using the projects page by skill-lync (projects.skill-lync.com). The PDF link for the project link is https://drive.google.com/drive/folders/1_Ssll24c2R1pmDvhURACpnf77K6Lh2Ft?usp=sharing

CONJUGATE HEAT TRANSFER ANALYSIS ON A GRAPHICS CARD Description of a conjugate heat transfer analysis: Conjugate heat transfer represents the combination of heat transfer in liquids and solids simultaneously. The mode of heat transfer in solids in conduction and convective mode of heat transfer is found predominately in…

https://drive.google.com/open?id=1XzkKzeUblRA3BaXk4rg6KRGBDrfblClR

COMPUTATIONAL STUDY ON SLOSHING EFFECT OF LUBRICANTS IN A GEAR BOX   INTRODUCTION Gear drives are used for transmitting power from one rotating shaft to another which are separated by a small distance. These shafts can be either parallel or inclined. Gears being more efficient way of transmitting power need to be…

https://drive.google.com/open?id=1sX4UE5obpeBJXVNzy2pyj8SnPnTF_Hjl

REPORT ON CFD PARTICLE TRACKING ANALYSIS OF A TYPICAL CYCLONE SEPARATOR     Abstract:  A cyclone separator is a device that is used to remove Particulate matter or “PM” from a liquid such as air or steam. Rotational effects and gravitational effects are used in the separation of Particulate matter.…

REPORT ON PARAMETRIC STUDY OF GATE VALVE   Parametric Study: A parametric study in Simulation is done to Map the change in inputs to the corresponding outputs. As long as the input parameter and output parameters are connected, the corresponding output values for change in input values are obtained.   In our…

Comments by Grader:1. Good job2. Publish the report using the projects page by skill-lync (projects.skill-lync.com). The PDF link for the project link is https://drive.google.com/drive/folders/1_Ssll24c2R1pmDvhURACpnf77K6Lh2Ft?usp=sharing

Design and CFD Analysis of a CPU fan to determine mass flow rate at different speed   Problem statement: To validate a cfd code to perform a cfd flow analysis of a typical axial fan using sliding mesh method and to validate the results using affinity laws or fan laws. Axial fan:  Axial fans are commonly used…

COMBUSTION SIMULATION OF A COMBUSTION AND ANALYSIS OF MASS FRACTION OF EACH SPECIES     Abstract: The aim of the project is to simulate the combustion of air and fuel mixture. The combustion model used was based on turbulent parameters that depends on turbulent parameters. The fuel mixture used was air-methane…

The Report for the solution can be found in the following Link https://drive.google.com/file/d/1657XRCOAQQn0M7FiGjMco2RbB0VJ_IcY/view?usp=sharing   Regards, Aravindhan V

Comments by Grader:1. Good job2. Publish the report using the projects page by skill-lync (projects.skill-lync.com). The PDF link for the project link is https://drive.google.com/drive/folders/1_Ssll24c2R1pmDvhURACpnf77K6Lh2Ft?usp=sharing