Adams challenge 4 - suspension creation
- New "Suspension Assembly" (*Subsystem does not run suspension simulation or test without assembly.)
- Open Assembly with subsystem "TR_Front_Suspension_flex.sub" from acar Shared directory.
- Select : Simulate in toolbar
- Select : Suspension Analysis
- Select : Parallel Wheel Travel
- Keeping parameters as default, Input : Cycle no. , Bump Travel and Jounce travel. OK
- Select : Review : then Animation Control from toolbar.
- Now you can play animated simulation.
- Time for Post-Processing in Review tool.
- Selecting toe_angle and side of the assembly, one can generate graphs for different simulation and check for optimum values to iterate and get desirable results.
[Screenshots Attached]