Benchmarking

Under body protective coatings is used to protect the vehicle chassis from external environment, to ensure the integrity and safety of cars. The use of UBC plays a very important role in the service life of the vehicle. In general, it is required to spray such a protective coating in the manufacturing of the new car. Due…

1. TATA HBX The homegrown automaker, Tata will enter into the micro SUV segment in India in the FY21. The company had showcased the H2X micro SUV concept at the 2019 Geneva Motor Show. The near-production model made its India debut at the 2020 Auto Expo. To be positioned below Nexon, the Hornbill will be based on…

Aim: Write a detailed report on Sheet Metal Component with good explanation on Sheet Metal modeling tools applied throughout the modeling.\' Design methodology: Create a sketch on the top and side plane As shown. Then extrude the sketch on the right plane, Then cutout with another sketch. Then add fillets and flange given…

Aim. Write a detailed report on Sheet Metal Component with a good explanation of Sheet Metal modeling tools applied throughout the modeling. Also, attach the Final model Images (Min. 4 images) of Sheet Metal Bracket Methodology: Create a sketch on the plane and extrude it. Then create a sketch on the top plane…

Aim: In this challenge, more focus will be given on the Industrial workflow while developing odd-shaped enclosures. Methodology: Create a sketch on the plane and extrude it. Then select sheet metal from solid and select 5 faces required. THEN ADD FLANGE AND JOG ON REQUIRED SIDES Then unbend part And add Bead and holes.…

BOX ASSEMBLY AIM: For this Challenge, you will be following the steps from the PDF given below and create the Sheet Metal BOX-Assembly as shown in the picture

CASING DESIGN   Objective: Is to create sheet metal casing   Methodology: Create a sketch on a plan as shown in fig 1 and use the tab feature and extrude it to 1 mm. Then create a sketch on the face as shown in fig 2 and take cutout on sheet. Then create a sketch on the face as shown in fig 3 and bend it. Then…

GAS TANK: At first, start a sketch on midplane and draw a spline and surface extrude it. Then draw a sketch on the top plane and cut the excess sheet. Then draw a spline on the right and midplane and project curve and join it with other sheets. Then mirror it then knit it and create a solid. Then sweep cut the tube hole.…

CHASSIS: Create a sketch on the front plane sketch the top tube. Create a sketch on the front and top plane create curves and project curve it to create the bottom tube and mirror it. Then create mounting plates to the bottom and side. Then create a sketch in the front plane and make a handle mounting tube and create a…

OIL TANK- At first create a sketch as  shown in above figure on the front plane. Then extrude it on direction 1 for 170mm and in direction 2 for 10mm. Then create a sketch on top plane as shown above. Then extrude it on both directions select through all dont merge bodies. Then select combine bodies from insert tool…

TRANSIMISSION BELT-  At first select the front plane and drawn two lines closed with two arcs in tangent with size line with 350mm length and circles with d1-140mm,d2-160mm diameter. Then selected offset option and seletcted the sketch to offset 6mm thick. Then exit sketch and extruded it with length of 88mm. And…